HRB 3S 5000mAh 11.1V 100C Lipo EC5 - Graphene
|
|
HRB 3S 100C 5000mAh Graphene LiPo Battery, made from a lithium graphene composite material. Added graphene material provides an increased discharge rate, capacity and lifespan. With the added graphene, batteries provide improved performance through lower internal resistance, and operate at a lower temperature.
Specifications:
Type: LiPo
Capacity: 5000mAh
Voltage: 11.1V
Connector Type: EC-5
Configuration: 3S
Length: 155mm
Width: 48mm
Height: 23mm
Weight: 422g
Maximum Continuous Discharge: 100C
Charge Rate (2C recommended) 5C
Battery Care
Warning! Always follow manufacturer warning labels when handling Lipo batteries.
In addition there are some common practices a user should follow to not void the warranty:
Break-in new packs by gently cycling them 3 to 5 times on a charger/discharger or in the model from full charge to no less then 50%- 60% of full mAh capacity.
Always check for excessive heat after a couple minutes of runtime depending on the battery mounting location, and power draw of the model.
Let battery cool to ambient temperature prior to charging.
Always charge on a non-conductive surface to avoid shorting the battery or charging equipment.
Avoid running Lipos heavily during hot seasons where the outside temperature exceeds 95F/35C
Do not keep Lipo batteries fully charged while not in use. Always discharge to storage (60%) until the next run time. This avoids premature "aging" of the cells.
Avoid discharging below 20% capacity. Doing so degrades the cells leading to high IR and reduces charge capacity.
Do not exceed recommended charge rates. A 5C charge rate implies a max input charge current of 25A on a 5000mAh battery regardless of the cell count.
Never charge unattended.
Use Lipo safe bags for charging/discharging and transportation/storage, and discontinue the use of batteries that are puffing or physically damaged no matter how small.
Charge Rate (2C recommended) 5C
Battery Care
Warning! Always follow manufacturer warning labels when handling Lipo batteries.
In addition there are some common practices a user should follow to not void the warranty:
Break-in new packs by gently cycling them 3 to 5 times on a charger/discharger or in the model from full charge to no less then 50%- 60% of full mAh capacity.
Always check for excessive heat after a couple minutes of runtime depending on the battery mounting location, and power draw of the model.
Let battery cool to ambient temperature prior to charging.
Always charge on a non-conductive surface to avoid shorting the battery or charging equipment.
Avoid running Lipos heavily during hot seasons where the outside temperature exceeds 95F/35C
Do not keep Lipo batteries fully charged while not in use. Always discharge to storage (60%) until the next run time. This avoids premature "aging" of the cells.
Avoid discharging below 20% capacity. Doing so degrades the cells leading to high IR and reduces charge capacity.
Do not exceed recommended charge rates. A 5C charge rate implies a max input charge current of 25A on a 5000mAh battery regardless of the cell count.
Never charge unattended.
Use Lipo safe bags for charging/discharging and transportation/storage, and discontinue the use of batteries that are puffing or physically damaged no matter how small.