Servo Lead & Terminal Crimping Tool

This is the tool you need to make custom length signal wires for your ESCs, receiver batteries and servos. It safely secures the connector pins on wire sizes between 14 and 28awg, without damaging the pin or the wire. Simply strip a short length of the shielding off the wires, install the connector pin into the tool, insert the wire into the pin, and squeeze the tool to crimp the pin in place. 
Unlike most terminal crimping tools, this tool will allow you to strip 12, 16 and 22awg wire, and includes a cutter as well. Crimps 20, 24 and 28 AWG wire.