1/16 TRX Steel Helical Spiral Gear Set
Hot Racing 1/16 Traxxas Steel Helical Spiral Gear Set w/Aluminum Cover Plate
Hot Racing steel helical spiral differential gear set for Traxxas 1/16 4X4 vehicles, including the 1/16 E-Revo, 1/16 Slash 4X4, and 1/16 Summit. This set is compatible with the front or rear differentials.
FEATURES:
- Aluminum carrier cover plate is anodized red
- Precision machined helical spiral cut gears offer inherently greater
strength and smooth operation than the factory bevel cut gears
YOU WILL RECEIVE:
- One (1) steel 15T pinion gear
- One (1) aluminum carrier
- One (1) aluminum carrier cover plate
REQUIREMENTS:
- Reuses Traxxas 7082 internal spider and carrier gears, as well as the output shaft seal and outdrives from the original differential
- Installation may require shimming for proper gear mesh. The gears should run freely without too much play and without binding. (If shimming are needed use Hot Racing W4X Shim)
- Use removable thread lock (blue threadlocking compound) on carrier screws
- Differential grease (Spl10G02)
SPECIFICATIONS:
- Carrier bearing boss diameter: 8mm
- Pinion length: ~19.5mm
COMMENTS:
- Replaces Traxxas 7079 ring and pinion and 7080 carrier cover plates (except for the output shaft seal)
- Shimming the differential correctly is an important step in building the perfect differential.